Paper bag printing machine is also a mechanical equipment, no matter when any product is in use, it is necessary to do maintenance, so that it can be used normally, and it will not often fail during operation. In general, the staff must check the low-speed operation of the preprinter before using it, and record the reading of the ammeter on the main electrical cabinet to judge when the machine restarts. Then look at the reference standard to see if its status is normal.
Then wash the ink off the ink roller on the water roller, this time also need to remove all the ink roller on the unit. The purpose of doing so is to avoid damage caused by prolonged extrusion deformation of the roller. The staff also need to check the bearings at both ends of the paper bag printing machine, maintain the rubber roll with the raising paste, and maintain the copper roll with the copper water. Here also wipe plate protection glue on the water roller and bucket roller. These are maintenance tasks that need to be done, and if you haven't been paying attention to them, now is the time to put them on the agenda. Otherwise, there will always be problems.
When paper bag printing machine is doing maintenance work, in addition to these places, it is also necessary to wipe a layer of lubricating oil after cleaning the ink hopper, ink key and ink roller. This is done for anti-rust effect. Moreover, it is also necessary to remove all the rubber cloth and gasket and PS plate inside the paper bag printing machine, and apply a little lubricating oil to the surface of the rubber drum and the stamping drum and the roller to maintain.
This is also done to prevent rust. After doing this, it will not affect its service life.
