Working principle of film cutting machine:
The working principle of the die-cutting machine is to use steel knives, hardware molds, steel wires (or templates carved from steel plates), and apply a certain amount of pressure through the embossing plate to cut the printed matter or cardboard into a certain shape. If the entire printed product is pressed into a single graphic product, it is called die-cutting; if a steel wire is used to press out marks or bent grooves on the printed product, it is called indentation; if two templates, yin and yang, are used, the mold is Heating to a certain temperature and hot-printing a pattern or font with a three-dimensional effect on the surface of the printed product is called hot stamping; if one base material is used to laminate on another base material, it is called lamination; excluding the remaining parts other than the genuine product is called hot stamping. To eliminate waste; the above can be collectively referred to as die-cutting technology.
Die cutting machine process:
The die-cutting process is the most commonly used process for packaging printed matter. It uses a die-cutting knife to form a die-cut plate according to the pattern required by the product design. Under the action of pressure, the printed matter or other ring blanks are cut into the required shape or form. Forming process of cutting marks. The creasing process uses a creasing knife or creasing die to press out line marks on the sheet through the action of pressure, or uses a roller to bend the sheet at a predetermined position. Usually the die-cutting and creasing process is a process in which the die-cutting knife and the creasing knife are combined in the same template, and die-cutting and creasing are performed simultaneously on the die-cutting machine, which is referred to as die-cutting. Process introduction The main process of die-cutting and creasing is: loading → adjusting pressure → determining rules → pasting base materials and auxiliary materials → trial pressure die-cutting → formal die-cutting and creasing → scrap removal → finished product winding or cutting into sheets → counting Package.
